1. The first step is selecting your spa.

-Different hot tubs have different electrical requirements depending on the manufacturer, model, voltage configuration, and equipment package. While many spas share similar requirements, the exact specifications can vary.
 

-For this reason, we strongly recommend choosing your spa before beginning any electrical work.
 

-Once your spa has been selected, we can provide the correct electrical information for your specific model.

 

2. We Recommend Using A Licensed Electrician

Electrical work should always be performed by a licensed electrician familiar with local building codes and safety requirements.
 

Your electrician can help determine:

• Proper breaker size

• Wire sizing requirements

• Disconnect placement

• Conduit routing

• Local permit requirements

• Final installation recommendations
   

3. Helpful Information To Gather

When requesting electrical estimates, it is helpful to know:

• The location of your main electrical panel

• The location where the spa will be installed

• The approximate distance between the two
   

Many electricians will use this information when preparing an estimate.
 

4. Typical 240V Spa Installations

Most full-size hot tubs require:

• 240 Volt service

• 50 Amp GFCI protection

• Dedicated electrical circuit

• Outdoor disconnect panel
   

A common installation uses #6 copper wire from the main electrical panel to the spa disconnect.
 

From the disconnect to the spa, wire size may vary depending on the spa model, manufacturer specifications, and local code requirements.

Your electrician should always follow the specifications provided for your particular spa.
 

5. Conduit & Wiring

Most installations use conduit to protect electrical wiring between the home's electrical system and the spa.
 

Depending on the installation, conduit may be:

• Surface mounted

• Installed underground

• Routed through walls or structures
   

Many spas also use flexible conduit near the spa itself to allow for proper routing and service access.
 

6. Concrete Pads & Stub-Ups

If you are installing a new concrete pad, many homeowners choose to have conduit stubbed up through the concrete before the spa arrives.

Others prefer to run conduit along the exterior of the slab after installation.
 

Both methods are common and your electrician can help determine which option works best for your property.
 

7. Our Courtesy Final Hookup

After your electrician completes the required electrical work, our delivery team can typically perform the final spa connection as a courtesy during delivery.
 

Please note:

• We are not performing electrical installation work.

• We are not electricians.

• Electrical work should be completed before delivery whenever possible.

• Final hookup availability may vary depending on the installation.
   

8. 110V Plug & Play Spas

Some smaller spas operate using standard household power.

These models typically plug directly into a properly functioning outlet and do not require a hardwired electrical installation.
 

Dedicated 120V Models

Certain 110V models may require a dedicated outlet or dedicated circuit.
 

Because requirements vary between manufacturers and models, it is important to verify the exact requirements for the spa you choose.
 

9. Every Spa Is Different

The information on this page is intended as a general overview.

The best way to ensure your electrical installation is completed correctly is to choose your spa first and then obtain the specific electrical requirements for that model.

Our team is always happy to help guide you through the process.